Quick answer: Pick a cube or pod light by job first (fog, ditch/side lighting, driving, work/scene or back-up), then beam, mount style (surface or flush) and size. For street fog use, choose a pod sold with an SAE fog beam, such as the Baja Designs Squadron SAE or S2 SAE pairs. Everything else on our cube lights page is auxiliary off-road, work or back-up lighting. Check whether a listing is a single light or a pair before you order.
Cube and pod lights are small, square LED lights that fit where a light bar won't: A-pillar ditch brackets, bumper fog pockets, rock sliders, bed racks and rear bumpers. This guide uses the specs printed on the 100+ pod lights we carry from Baja Designs, RIGID Industries, TrailFX and KC HiLiTES. Output and size numbers are quoted only as each listing gives them.
Step 1: What will the lights do?
| Job | Beam to look for | Typical spot |
|---|---|---|
| Fog lights on the road | SAE fog beam (sharp top cutoff), often amber | Bumper fog pockets |
| Ditch / side lighting off-road | Wide cornering, flood or side-shooter | A-pillar brackets |
| Long-range trail lighting | Spot, hyperspot or driving/combo | Bumper, hood or roof brackets |
| Work area, camp, job site | Flood, work/scene or diffused | Bed rack, headache rack, rear bumper |
| Backing up and hitching | Flood or diffused back-up kit | Rear bumper or hitch area |
Step 2: Know the beam names
- Spot / hyperspot: a narrow, long beam for distance. RIGID lists a hyperspot optic on the D-Series PRO 504713 and D-XL PRO 322413.
- Driving / driving-combo: a mix of distance and spread. Examples: Baja Designs S2 Sport 547803, Squadron 2.0 Sport 55-7803-2, RIGID D-Series PRO 502313.
- Flood: a wide, shorter beam. Examples: RIGID D-Series PRO 202113, SR-M PRO 902113.
- Diffused: a soft, even spread with no hot spot, good for work and back-up lighting (RIGID 202513, 602513).
- Wide cornering (Baja Designs): a very wide beam for ditch and side lighting (S1 387805, Squadron 2.0 Sport 55-7805-2).
- Work/scene (Baja Designs): an even close-range flood (S1 387806, S2 Pro 487806, Squadron 2.0 Pro 49-7806-2).
- SAE fog: a fog beam made to meet SAE J583 (see Step 5).
Step 3: Pick a size and family
Dimensions below are from the listings (Baja Designs gives height x length x depth in inches). RIGID listings give output, watts and LED count rather than housing size, so check the product page or RIGID's drawings before you buy brackets.
| Family | Listed size / output | Notes from the listings |
|---|---|---|
| Baja Designs S1 | 2.1 x 2.1 x 2.1 in.; 2,320 lumens | Smallest Baja cube we carry; wide cornering and work/scene, clear or Baja Amber; single (380005) or pair (387805) |
| Baja Designs S2 Sport / S2 Pro | 1.76 x 2.93 x 1.68 in.; Sport 1,581 lumens, Pro 2,245 lumens | Slim rectangular pod; spot, driving/combo, wide cornering, work/scene; flush-mount versions (541005) |
| Baja Designs Squadron SAE / Squadron-R SAE | 3.07 x 3.07 x 2.77 in.; 2,420 lumens, 29 W | SAE fog beam, wiring harness included (257801, 247802) |
| Baja Designs Squadron 2.0 Sport / Pro | 3.29 x 2.84 x 3.32 in.; Sport 3,200 lumens at 30 W, Pro 5,921 lumens at 65 W | Spot, driving/combo, wide cornering, work/scene; Squadron-R 2.0 pair with harness (58-7803-2) |
| RIGID SR-M PRO | 2 LEDs; 1,584 raw lumens (driving 912313: 3 LEDs, 2,376) | Compact; flood, spot, diffused, driving; surface or flush |
| RIGID D-Series PRO | 4 LEDs; 3,168 raw lumens, about 30 W | Spot, flood, diffused, hyperspot; black or white housing; Midnight Edition smoked versions |
| RIGID SR-Q PRO | 4 LEDs; 3,168 raw lumens (driving 914313: 6 LEDs, 4,752) | Square SR-Series pod; flood, driving, Midnight spot-diffused |
| RIGID D-SS PRO side shooter | 7–8 LEDs; 5,544–6,336 raw lumens | Extra LEDs aimed out the sides for ditch lighting; single or pair |
| RIGID D-XL PRO | 9–12 LEDs; 7,128–9,504 raw lumens | Bigger cube for more reach; flood, spot, hyperspot, driving |
| RIGID Q-Series PRO | 16–24 LEDs; 12,150–19,008 raw lumens, 123–195 W | Largest pods on the page; plan wiring for the current draw |
| TrailFX cubes | 2X2 (4 LEDs), 3X2 (6 LEDs), PODSID (15 LEDs); 4 in. square 2X2FMBKF1 / 4X4WLAMF1 | Driving/fog and work lights; PODSIDEF lists 9,000 raw / 2,800 effective lumens at 75 W |
| KC HiLiTES FLEX ERA 1 | Up to 2,430 lumens; 5 W or 23 W | Single-light master kit 1265; listing gives flood, spread and spot candela figures |
Raw vs effective lumens: RIGID and TrailFX list raw lumens (LED output before the optic). TrailFX also lists effective lumens on some lights (for example 2,400 raw / 1,500 effective on 2X2CFFMB). Compare like with like, and look at beam distance or candela when a listing gives them.
Step 4: Surface mount or flush mount?
- Surface mount lights bolt onto a bracket (A-pillar, bumper, rack). Easiest to install and aim.
- Flush mount lights sit inside a cut-out in a bumper or panel for a clean look. You cut the opening, so measure the listing's cut-out size first. Examples: RIGID D-Series PRO flush 212113, SR-M PRO flush 922113, Baja Designs S2 Sport flush 541005, TrailFX 2X2CFFMB.
Step 5: Road use (SAE fog pods)
Most pod lights are auxiliary lights for off-road and work use. The pods on our page sold with a street fog beam are:
- Baja Designs Squadron SAE 257801 (clear) and 257811 (Baja Amber): listings say SAE J583 compliant, 2,420 lumens, wiring harness included, and "not DOT approved".
- Baja Designs Squadron-R SAE 247802: SAE J583 fog beam, harness included.
- Baja Designs S2 SAE 237811 (Baja Amber): listed as a road-legal auxiliary fog light pair with mounts and harness.
Lighting laws vary by state, including how many auxiliary lights you can run, where they mount and when they can be on. Check your state's rules, and keep off-road beams covered or switched off on public roads. More on fog colors: yellow vs white fog lights. Round SAE options are in our round lights guide.
Step 6: Back-up and special-purpose pods
| Need | Options on our page |
|---|---|
| Back-up light kit | RIGID Ignite surface (Back-Up Light Kit 20541) or flush 20641; SR-M PRO 980003 (surface) / 980013 (flush); SR-Q PRO 980023 (surface) / 980033 (flush); Baja Designs S2 Pro flush reverse kit 487807 |
| Single small work light | RIGID Ignite (1 LED, 1,000 raw lumens, 12 W) spot 20511 / flood 20521; TrailFX work lights 3X2WLF1 and 4X4WLAMF1 |
| Ditch / side lighting | RIGID D-SS PRO side shooters (262113 flood pair, 262313 driving pair); Baja Designs wide cornering pods |
| Color-changing accent / camp light | RIGID Radiance+ RGBW 202053 and Radiance+ Pod XL RGBW 322053 |
| Spreader / halo pods | RIGID SR-L Series spreader pods with red halo, surface 53122 or flush 53222 |
| Powersports | RIGID Adapt XP 300414 / 300415 (titled for powersports; 3 lighting zones with GPS module) |
Step 7: Single or pair, harness or not
- Titles say "Pair" or "Single" on most listings; RIGID's "What's in the package" line says Light or Lights. Most fog, ditch and back-up setups need two.
- Some kits include a wiring harness (Baja Designs Squadron SAE, S2 Pro 487803, Squadron-R 2.0 58-7803-2; RIGID D-Series PRO and SR-Series list a harness). Some don't: the Squadron 2.0 Sport wide cornering pair 55-7815-2NH says the harness is not included.
- For switches, relays and harnesses see light wiring kits and switches; for brackets see light mounts and brackets; for amber and protective covers see light covers and accessories.
Wiring basics
- Use a fused relay harness and a switch for every auxiliary light circuit. Bigger pods (Q-Series, D-XL) draw more current, so size the harness for the total watts.
- Wire back-up kits to the reverse circuit or a switch, following the kit instructions.
- Aim lights on level ground after mounting. Step-by-step: how to install an LED light bar (mounting and wiring).
Cube vs round vs light bar
Cubes fit tight spots and come in the most beam choices. Round lights give a classic look and come in larger diameters. A light bar spreads light across the full width. Many trucks run a bar or round lights up front and cubes on the A-pillars and rear. See how to choose an LED light bar.
FAQ
What size cube light fits an A-pillar mount?
Most A-pillar ditch light brackets are made for compact 2–3 inch cubes, like the Baja Designs S1 (2.1 in.) or S2, or RIGID SR-M / D-Series PRO pods. Check the bracket listing for the light it was made for.
Are cube lights street legal?
Only pods sold with a street-compliant beam, like the Baja Designs Squadron SAE pairs (SAE J583 fog), are meant for road use as fog lights, and state rules still apply. Spot, driving, flood and work pods are for off-road and work use.
Are lumens per light or per pair?
RIGID lists output per light model (a single D-Series PRO and a D-Series PRO pair both list 3,168 raw lumens), so a pair gives you two lights at that rating. If a listing isn't clear, check the product page or ask us before ordering.
Amber or clear?
Amber (Baja Amber, RIGID amber PRO lenses like 20252 and 262214) cuts glare in dust, rain and fog. Clear gives the most light. Amber covers are another option for clear pods.
Can I use pod lights as reverse lights?
Yes. Back-up kits like RIGID 980003 or Baja Designs 487807 are made for it, or wire a pair of flood or diffused pods to a switch.
Shop: cube lights · round lights · LED light bars · fog lights · rock lights · all lighting


